measurement_Service Information_Shanghai Zoie Industrial Co., Ltd.

Shanghai Zoie Industrial is a professional high-end sunshade and rain protection project 136-3669-1913 中文

Service Information

measurement

Different types of awning are selected according to the different installation positions of the products

1、 Measurement of curved arm awning:

Determination of awning width (hereinafter referred to as awning width) and measurement of three types of balconies

1. Concave balcony

First, measure the limit width of the site balcony with a meter ruler (this size is the theoretical limit value that the awning can be installed). The canopy width is the above limit size minus 50 mm (this size is the actual limit value that the awning can be installed).

2. Semi concave balcony

First, measure the limit width of the balcony on site with a meter ruler.

The width of awning is the above size minus 50mm, which is considered from the angle of symmetry of awning installation. The actual size can be appropriately lengthened according to the requirements of customers, but the lengthening range must be calculated separately according to the width of balcony and the position of installation feet.

3. Open balcony

First, measure the limit width of the balcony on site with a meter ruler. The canopy width is the above measured dimension. The actual size can be lengthened at both ends according to the requirements of customers, but the lengthening range must be calculated separately according to the width of balcony and the position of installation feet.

2、 Measurement of ceiling awning:

The ceiling type sunshade is generally installed on the top of the outdoor sunshine room, which is determined according to the actual size of the sunlight room and customer requirements. Tilt according to the roof of the sunshine room. If the sunlight room is flat roof, we can negotiate with customers to give the appropriate slope.

3、 Measurement of window awning:

The window type awning is installed outside the window, which is divided into in frame installation and outside frame installation; the actual size is determined according to the actual limit value of sunshade installation on site and customer requirements.

4、 Determine the operation mode and direction:

Operation mode: handle operation and motor operation;

Operation orientation: left operation, right operation and indoor operation;

Note: confirmation of operation orientation: people always stand on the opposite side of the awning as the reference.

Home

Products

QQ

Telephone